Unitronics Vision V130-T2 - Page 16

Vision™PLC+HMI Installation Guide
16
Unitronics
Digital Outputs
Number of outputs
12 transistor pnp (source)
Output type
P-MOSFET (open drain)
Isolation
None
Output current
(resistive load)
0.5A maximum per output
3A maximum total per common
Maximum frequency
50Hz (resistive load)
0.5Hz (inductive load)
PWM maximum frequency
0.5KHz (resistive load). See Note 2
Short circuit protection
Yes
Short circuit indication
Via software
On voltage drop
0.5VDC maximum
Power supply for outputs
Operating voltage
20.4 to 28.8VDC
Nominal voltage
24VDC
Notes:
2. Outputs 0 to 6 can be used as PWM outputs.
Graphic Display Screen
Item
V130-T2
V130J-T2
V350-T2
V350J-T2
V430J-T2
LCD Type
STN, LCD display
TFT, LCD display
TFT, LCD display
Illumination backlight
White LED
White LED
White LED
Display resolution
128x64 pixels
320x240 pixels
480x272 pixels
Viewing area
2.4"
3.5"
4.3"
Colors
Monochrome
65,536 (16-bit)
65,536 (16-bit)
Screen Contrast
Via software
(Store value to SI 7,
values range: 0 to
100%)
Fixed
Fixed
Touchscreen
None
Resistive, analog
Resistive, analog
‘Touch’ indication
None
Via buzzer
Via buzzer
Screen brightness control
Via software
(Store value to SI 9,
0 = Off, 1 = On)
Via software
(Store value to SI 9, values range: 0 to 100%)
Virtual Keypad
None
Displays virtual keyboard when the application requires
data entry.
Keypad
Item
V130-T2
V130J-T2
V350-T2
V350J-T2
V430J-T2
Number of keys
20 keys,including 10
user-labeled keys
5 programmable function keys
Key type
Metal dome, sealed membrane switch
Slides
Slides may be
installed
in the operating
panel faceplate to
custom-label the
keys. Refer to V130
Keypad Slides.pdf.
A complete set of
blank slides is
available by separate
order
Slides may be installed
in the operating panel
faceplate to custom-label
the keys. Refer to V350
Keypad Slides.pdf.
Two sets of slides are
supplied with the
controller: one set of
arrow keys, and one
blank set.
None