Press the mono button to route the monitor source direct inputs in mono instead of stereo. The
button lights blue when enabled.
Important: The mono button applies to Volt’s hardware inputs only.
(9) Host Indicator
The host indicator is lit blue when Volt is recognized by the computer or device.
(10) Monitor Knob
Rotate this knob to adjust the volume of speakers connected to the Monitor outputs. The output
signal level meters indicate the output levels.
(11) Headphone Output
Connect stereo headphones to this output. Headphones are connected with a ¼” (6.35 mm)
TRS plug. If your headphones have a ⅛” (3.5 mm) plug, use a TRS ⅛” to ¼” adapter.
(12) Headphone Volume Knob
Adjust the headphone volume with this knob. The headphone volume control is independent
from the Monitor volume control.
Note: The monitor output and headphone signals are the same.
Rear Panel
To Next Page
Loading...
