Apply power to Volt with this switch.
(20) Kensington Security Slot
Use with Kensington-compatible security devices to secure Volt hardware.
Troubleshooting
Problem Solution
No power
Make sure Volt is connected to a port that meets USB 2.0
specifications.
If bus power is insufficient, connect Volt to external 5VDC power to
compensate for the underpowered USB port.
Make sure the power switch is in the ON position.
Host indicator
doesn’t light
Power Volt off and back on.
Try a different USB port or USB hub.
Try a different USB cable.
Crackling audio,
dropouts, glitches
Increase the buffer size setting in the software on your computer. When
recording, you can use direct monitoring to record without latency at
higher buffer sizes.
(PC) ASIO driver
not available in
DAW
Install the Volt hardware driver with the UA Connect app.
Other Issues [links to cs videos and troubleshooting section]
To Next Page
Loading...
