Device Code Verification
You c a n verify any device code that you have pro-
grammed. This will be helpful in retrieving an
existing device’s Manufacturer Code programmed
into your Kameleon-C6 Remote for future refer-
ence.
TO VERFIY A DEVICE CODE
1. Press the desired device mode key on your
Kameleon-C6 Remote.
2. Press Setup for at least 3 seconds. The bottom
of the IR indicator will blink twice.
3. Press 9 9 0 on the keypad. The bottom of the IR
indicator will blink twice.
4. To determine the first digit of your 4-digit
code, press 1 and count the number of blinks
on the bottom part of the IR indicator. For
example, if there is one blink, then the digit is “1”
-– if there is two blinks, the digit is “2”– and so
on. If there are no blinks, the digit is “0.”
5. For the second digit, press 2 and count the
number of blinks .
6. For the third digit, press 3 and count the num-
ber of blinks .
7. Lastly, for the fourth digit, press 4 and count
the number of blinks .
R
EMEMBER
• Y
OU ARE VERIFYING THE CODE FOR THE SELECTED DEVICE
.
• I
F AFTER PRESSING 9 9 0, ANY DIGIT OTHER THAN 1 IS PRESSED, YOU R
K
AMELEON-C6 WILL EXIT THE SETUP MODE.
• I
FAKEY IS NOT PRESSED WITHIN 30 SECONDS,YO UR KAMELEON-C6
REMOTE WILL EXIT THE DEVICE CODE VERIFICATION.
Adjusting Keypad Brightness
You c a n c u s t o mize the backlight setting on your
Kameleon-C6 keypad.
TO ADJUST BRIGHTNESS
1. Press Setup for at least 3 seconds. The bottom
of the IR indicator will blink twice.
2. Press 9 7 4 on the keypad. The bottom of the IR
indicator will blink twice.
3. To increase the brightness press CH+. To
decrease the brightness press CH-.
4. Lastly, press Setup again to save the new
brightness setting.
14 Device Code Verification/Adjusting Keypad Brightness
KAMELEON-C6 REMOTE
To Next Page
Loading...
