Universal Laser Systems PLS3.75 - Page 18

SAFETY
Section 1-10
EU Declaration of Conformity
Product Identification:
PLS3.75, PLS4.75, PLS6.75, and PLS6.150D
Laser Engraving and Cutting Systems
Manufacturer: European Office:
Universal Laser Systems, Inc. Universal Laser Systems GmbH
16008 N. 81
st
St. Lerchenfelder Guertel 43
Scottsdale, AZ 85260 A-1160 Vienna/Austria
USA
The manufacturer hereby declares that the equipment specified below is in
conformity with the following directives:
89/336/EEC (EMC Directive)
73/23/EEC (Low Voltage Directive)
98/37/EEC (Machinery Directive)
2002/95/EEC (ROHS Directive)
2002/96/ECC (WEEE Directive)
based on the standards listed.
Standards Used:
Safety:
EN 60950: 2002
EN 60825-1: 2002 (Class 3R)
EMC:
EN 55024 1998 (Class A)
EN 55022: 2003 (Class A)
EN 61000-3-2: 2001 (class A)
EN 61000-3-3: 2002
EN 61000-4-2: 2001 (4kV CD, 8kV AD)
EN 61000-4-3: 2003 (3 or 10 V/m)
EN 61000-4-4: 2002 (1 or 2 kV power line)
EN 61000-4-5: 2001 (class 3)
EN 61000-4-6: (3 or 10Vrms)
EN 61000-4-8
EN 61000-4-11
Note: This is not a declaration of conformity. The importer of this equipment
supplies the declaration of conformity.
Warning
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.