11
Attaching Cart to Laser System
2.2 OPERATING ENVIRONMENT
Before the system is installed, choose a suitable location. Follow the guidelines below:
m Avoid places where the system may be exposed to high temperatures,
dust, or high humidity (humidity exceeding 70% or where the
temperature is near the dewpoint). The laser system should be installed in
an office type environment.
m Avoid places where the system may be exposed to high levels of vibration
or electrical noise. We recommend using a high quality surge protector
(15 Amp capability) to protect the laser engraving system's electronics.
m Avoid small enclosed areas where ventilation is poor.
m Choose a place where the ambient operating temperature will remain
between 60 and 75 degrees Fahrenheit.
m Choose a place which provides a short and direct path to the exhaust
duct work (not provided).
m If planning to connect the laser engraving system to a computer through
the parallel port, choose a location where the computer can be placed
within 10 feet of the machine since this is the recommended maximum
distance for a parallel cable.
To Next Page
Loading...