9
SECTION 2 - INSTALLATION
2.1 UNPACKING AND ASSEMBLING THE SYSTEM
The laser engraving machine is shipped in one crate that contains the system, a cart with casters and
various accessories. The following steps outline the unpacking and assembly of the system. Please
follow these steps carefully.
IMPORTANT
Save the shipping crate. If the system must be returned for
service, it will have to be packed in its original shipping crate.
1. Remove the top and four sides from the wooden shipping crate. Remember, after the laser
engraving system is assembled, store the flattened crate in a dry place.
2. Remove the cart panel and accessories box from the crate. The cart panel is shipped between two
pieces of foam in front of the laser engraving system and the accessories box is shipped behind the
system underneath the enclosure with the four fans mounted on it.
3. Carefully remove the foam which protects the viewing window on the top of the system and remove
the tape which holds the top door in place.
4. Remove the box containing the two cart legs. This box is shipped inside the laser engraving system.
To remove the box, open the top lid of the system and raise the engraving table by turning the
engraving table adjusting knob clockwise until the table is raised high enough to free the box
underneath it. Then open the front door of the system and slide the box out through the front
opening.
5. Open the accessories box and remove the four black casters and the bag of hardware. The
hardware bag should contain the following:
(8) 10-32 Allen head screws
(8) #10 lock washers
(4) 1/4-20 Allen head screws
(4) 1/4 " ID flat washers
(1) 5/32 inch Allen wrench
(1) 3/16 inch Allen wrench
A 3/4 inch wrench provided in the accessories box is needed to complete the stand assembly.
6. Using the smaller Allen wrench, attach the two legs to the center panel with the eight 10-32 Allen
head screws and #10 lock washers as shown in the figure below.
To Next Page
Loading...