Universal Laser Systems ULS-25 - Appendix C: Serial Port Cable Requirements

C
APPENDIX C - SERIAL PORT CABLE REQUIREMENTS
To use the serial port on the laser system, a proper serial cable must be used. The diagram below
describes the serial cable configuration required. This is a standard null modem serial cable.
(2)
(3)
(4)
(5)
(6)
(7)
(20)
(2)
(3)
(4)
(5)
(6)
(7)
(20)
Pin No. Pin No.
Laser System
IBM-PC or COMPATIBLE
25 pin connector 25 pin connector