27
RUBBER STAMP and INVERT FILL
These two selections will only appear in the driver if the Rubber Stamp option has been purchased. For
a full explanation on how to use this option, refer to section 4.7. Again, please read the rest of this
manual up to that point before attempting to use this option. A full understanding of how the laser
system works is essential to producing correct results.
FILE
A unique feature of the driver is being able to store the power settings that are currently on screen. By
selecting FILE and then SAVE SETUP FILE, all settings will be stored in a file that can be named as
desired. The file extension, however, must remain as .LAS for the driver to recognize this file as a
setup file. These files can be stored in any directory and may be retrieved by selecting FILE and then
LOAD SETUP FILE.
The LASER.INI file can be thought of as being a file that stores the current power settings when the
OK button is pressed. This gives the driver the ability to restore these settings every time the driver is
accessed. Without this file, The power settings would have to be entered in every time the graphic is
sent to print. Selecting FILE then LOAD LASER.INI SETTINGS will restore the settings that were
saved the last time the OK button in the driver was pressed. Once the OK button is selected, the
current power settings will be stored in the LASER.INI file and the original ones will be erased.
HELP
Select this option to access HELP on the use of the ULS Windows printer driver. Selecting HELP
and then ABOUT will display the current driver version number and our copyright notice.
To Next Page
Loading...