58
ANODIZED ALUMINUM
TYPE POWER SPEED PPI PASSES DEPTH
RASTER ENGRAVING 30 100 500 1 .001”
COMMENTS: The power required is dependent on the thickness of the anodized coating. Do not
overpower because the anodized will either be dull in appearance or the engraving lines will be too
thick.
TYPE POWER SPEED PPI PASSES DEPTH
VECTOR ENGRAVING (fast) 2 1 500 1 .001”
COMMENTS: Different anodized coatings will require higher or lower power settings.
TYPE POWER SPEED PPI PASSES
DEPTH
VECTOR ENGRAVING (faster) 20 10 500 1 .001”
COMMENTS: Power must be increased if engraving at a faster speed.
To Next Page
Loading...