61
CORIAN or AVONITE
TYPE POWER SPEED PPI PASSES DEPTH
RASTER ENGRAVING 100 100 500 1 .005”
COMMENTS: Mask first before engraving if planning to paint fill.
TYPE POWER SPEED PPI PASSES DEPTH
RASTER ENGRAVING (deep) 100 75 500 1 .010”
COMMENTS: Mask first if planning to paint fill.
TYPE POWER SPEED PPI PASSES DEPTH
RASTER ENGRAVING (deeper) 100 50 500 1 .015”
COMMENTS: Mask first if planning to paint fill.
TYPE POWER SPEED PPI PASSES DEPTH
VECTOR ENGRAVING 50 10 500 1 .010”
COMMENTS: Mask first if planning to paint fill.
ADDITIONAL COMMENTS
Laser engraving this type of material produces spectacular results especially when the engraved area is
paint filled. If paint filling, it is a good idea to mask first and then engrave through the masking. In this
way, when ready to paint fill, the material is already masked. Spray painting seems to be the easiest.
Using a paint brush is acceptable but time consuming. Use the paint sparingly. Excess paint can
accumulate on the edges of the engraving which will make mask removal difficult and leave unsightly
ridges. Remove the masking after the paint has dried. Engraving this material without paint filling can
work but most of the time there is very little contrast which makes the engraved area difficult to see.
To Next Page
Loading...