75
WOOD - FINISHED WALNUT
TYPE POWER SPEED PPI PASSES DEPTH
RASTER ENGRAVING 100 100 500 1 .020”
COMMENTS: Engrave unmasked. If masking, reduce the speed setting to 80% to get the same
depth.
TYPE POWER SPEED PPI PASSES DEPTH
RASTER ENGRAVING 100 75 500 1 .030”
COMMENTS: Engrave unmasked. If masking, reduce speed to 55% to get the same depth. To
engrave deeper it is recommended to make more passes instead of reducing speed.
TYPE POWER SPEED PPI PASSES DEPTH
VECTOR ENGRAVING 25 10 500 1 .030”
COMMENTS: Engrave unmasked.
TYPE POWER SPEED PPI PASSES DEPTH
VECTOR CUTTING 50 1 500 1 .125”
COMMENTS: Elevate at least 1/8” off of the engraving table. Lightly dampen bottom side with
water. Both surfaces can also be masked and dampened with water. Elevating will let heat and smoke
escape from underneath and prevent burning.
ADDITIONAL COMMENTS
When engraving wood with a laser, a brown, maple syrup like residue will deposit on the surface of
the wood. This is normal and impossible to eliminate by POWER, SPEED, or PPI changes. More
residue will be present when engraving deeper and/or slower. This residue washes off with water and a
To Next Page
Loading...