81
CLEANING THE WINDOW
A small window is located inside the machine underneath the protective overhang for the motion system
arm. Slide the motion system out from underneath the overhang to access the window. This window
seals the rest of the system from the processing area and the outside of the window will need to be
cleaned regularly. Follow these steps to clean the window:
1. Use a stream of lens cleaning solution from the small plastic wash bottle to flush the surface
of the window.
2. Soak a lens tissue with lens cleaning solution and then gently wipe the surface of the
window. Use more lens tissue soaked in lens cleaning solution if necessary.
3. Finally, dry the window using a dry lens tissue.
4. Inspect the window and repeat the procedure if necessary until the window is clean.
To Next Page
Loading...