17
URC-200
Advanced Setup
After you’ve finished all your basic setup, you can
choose to make operation easier by customizing the
Automator just the way you want, using the Advanced
Setup features described in this section.
Editing Button Labels
You can change the name of any of the display buttons
(including Favorite Channels) by following these steps:
Press and hold both the MAIN and ENT (Enter)
buttons for approximately three seconds. The top
of the display will show “SETUP”. You are in
SETUP mode now.
Note: You have 30 seconds to perform a step while you are
in SETUP mode. If you don’t press a button within that time,
the Automator will time out and return to normal operation.
Press the EDIT button.
The display changes to the EDIT menu. Press the
TEXT button.
1
2
3
EDIT
Button
TEXT
Button
To Next Page
Loading...
Need help?
General
