MSC-400 Reference Manual
Rev 4
10
VS-1006 VOLTAGE POWER SENSOR
The VS-1006 Voltage Power Sensor allows voltage output of a system component to be used to monitor
that component’s ON/OFF status for power management when the device does not have discrete
commands or a composite video output is not available for video sensing. Some components provide 12V
Status Outputs while with other applications, a DC power supply plugged into a component’s switched
outlet can be used to provide device status.
VS-1006 Voltage Power Sensor Features
5 VS-1006 Voltage Power Sensor
26. Sensor Plug – One four-circuit 3.5 mono mini plug connects to one of the Video or Voltage Sensor
Inputs on the MSC-400 rear panel.
27. Power LED – One red LED illuminates to indicate the VS-1006 is properly connected to and powered
from the MSC-400.
28. Sensed Voltage Input – One two-pin plug-in connector terminal connects to the AC or DC voltage
output of the device being sensed. POLARITY: Not critical on VS-1006 end. RATING: 3-25 V AC or
DC. WIRE GAUGE: Up to 14AWG.
To Next Page
Loading...