Desk Reset Procedure
IMPORTANT! Before using your desk, perform the Initial Desk Reset
Procedure below.
Initial Desk Reset Procedure
A. Press and hold the DOWN button for approximately 10 seconds,
then release the button. If you have a Keypad with a display, it
will read “RST”.
B. Press and hold the DOWN button again, the desk will lower a
little, then rise a little, and then stop.
C. Release the button. Your desk is now ready for use! If you are
using an Advanced Keypad, see the Programming section for
further information on how to use your Keypad.
1 2 3 4 M
Desk Placement (Continued)
B. Readjust your grip and continue to rotate the desk until it is
rightside up with both Feet completely on the oor.
C. Position your desk where you would like it to be. Never lift the
desk by just the desktop, doing so will put undue stress
on the attachment screws. Be sure to hold the frame Side
Brackets when lifting.
• If your desk has Casters: Moving is easy! If your Casters
include locks, make sure they are unlocked and roll the desk
to the desired location. Be sure to relock the Casters to keep
the desk stationary.
• If your desk does not have Casters: Using two people, lift
your desk (do not drag it) by holding onto the desktop and
Side Brackets together.
D. Adjust the Leveling Glides as needed to level the desk.
E. Check your desk’s surroundings to make sure there will be
no obstacles within the desk’s path while it is being raised or
lowered. Do not place any objects underneath the desk that
are taller than 21” and be aware of any accessories mounted
underneath your desk.
F. Ensure that the Power Cord and all accessory cords are long
enough to accommodate the raising and lowering of your desk.
G. Plug your desk into a grounded, 120V power outlet.
To Next Page
Loading...
