16 17
UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book
SEWN-ON LATCH PLATE
OVERVIEW OF VEHICLE SEAT BELT SYSTEMS
If you do not use lower anchor to properly secure the child restraint you
must use the Vehicle Seat Belt System. Seat belt systems vary by make,
model, and year of your vehicle. There are some vehicle belts that will NOT
work with this child restraint or that require additional steps.
CHECK YOUR VEHICLE OWNER’S INSTRUCTION BOOK
for information regarding your vehicle seat belt system(s).
This child restraint is compatible with most vehicle seat belt systems.
VEHICLE SEAT (LAP/SHOULDER BELT)
SLIDING LATCH PLATE
LOCKING LATCH PLATE LOCKING LATCH PLATE
VEHICLE SEAT (LAP ONLY BELT)
WEBBING
WEBBING
LATCH PLATE LATCH PLATE
BUCKLE BUCKLE
OVERVIEW OF LATCH
Most vehicles manufactured after September 1, 2002 are equipped
with LATCH (Lower Anchors and Tethers for CHildren). Check your
vehicle owner’s instruction book to determine lower anchor compatible
seating positions.
NOTE: No tether is required with this rear-facing carrier. Only lower
anchors are used.
OUTBOARD
LOWER
ANCHORS
INBOARD
LOWER
ANCHORS
OUTBOARD
LOWER
ANCHORS
22"=
NOTE: In order to use the rear center seating position with lower anchor,
the distance between the lower anchors may be up to 22 in and the seating
position must be approved by the vehicle manufacturer. If spacing between
the lower anchors is greater than 22 in or if the seating position is not approved
by the vehicle manufacturer then use the vehicle seat belt for installation.
VEHICLE COMPATIBILITY
VEHICLE COMPATIBILITY
0225_MESA_INS_V4.indd 16-17 3/19/15 11:07 AM
To Next Page
Loading...
Need help?
General
