34 35
UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book
SECURING YOUR CHILD
PINCH TEST
54
6
STEP 4: Pull up on the harness to
remove excess slack around the
child’s legs.
STEP 5: Pull the harness adjuster
strap to snugly adjust the harness
straps around your child.
STEP 6: Close retainer clip and
position at armpit level. Make sure
the shoulder pads don’t interfere
with positioning the chest clip.
HARNESS SHOULD BE SNUG.
Pinch harness webbing at child’s
shoulders. If you can pinch
webbing, the harness is too
loose and should be tightened.
GENERAL USE
NOTE: For smaller babies, it is recommended to remove the harness pads
for a more secure fit.
GENERAL USE
STEP 1: Place carrier on base
until a click is heard .
STEP 2: Check for a secure
connection by pulling up on
carry handle
.
STEP 1: Pull and hold carrier release
button on back of the carrier.
STEP 2: Lift carrier off base.
RELEASING CARRIER FROM BASE
ATTACHING CARRIER TO BASE
NOTE: Handle can be in any of the
three (3) locked positions for use in
the vehicle.
1
2
0225_MESA_INS_V4.indd 34-35 3/19/15 11:07 AM
To Next Page
Loading...
