32 33
UPPAbaby MESA Instruction Book UPPAbaby MESA Instruction Book
This child restraint has an adjustable head restraint and no-rethread harness
system that is easy to adjust to properly secure the child.
STEP 1: Adjust the head restraint by pulling on the adjuster tab and
sliding the head restraint up or down .
STEP 2: Position the head restraint so the harness rests at the child’s shoulders
or slightly below.
SIP CARRIAGE + HARNESS POSITIONING
1 2
GENERAL USE
GENERAL USE
SECURING YOUR CHILD
1
3
STEP 1: Loosen the harness by
pressing on the harness adjuster
release button and pulling out the
shoulder straps.
STEP 2: Open the retainer clip,
unbuckle the harness, and tuck
the latch plates into the side
pockets to hold harness open.
STEP 3: Place infant in child restraint
making sure their body is making
full contact with the seating surface.
Place harness over child and insert
buckle tongues into the buckle until
a “click” is heard. Pull up on the
buckle tongues to make sure they
are locked.
NOTE: When using the inner
slot with a small infant, a rolled
washed cloth or small blanket
may be placed in between the
crotch of the infant and the buckle.
2
INFANT INSERT (4-8 LBS)
To ensure a better fit for smaller infants, we
recommend using the infant insert (included)
between 4 and 8 lbs. Remove infant insert
when infant begins growing on top of the
buckle making it difficult to buckle harness.
NOTE: Never use non-regulated products with
this child restraint, unless approved by UPPAbaby.
0225_MESA_INS_V4.indd 32-33 3/19/15 11:07 AM
To Next Page
Loading...
