To Next PageTo Next PageWhat to do if Upright Lifting Systems charger overheats?
If the Upright Lifting Systems charger overheats, move the machine to a cooler area. Allow the machine to cool before connecting to the AC source.
What to do if Upright Lifting Systems has AC power problem?
If there is an AC power problem with your Upright Lifting Systems, the AC outlet, extension cord, or plug might be faulty, or the AC wire could be broken. Check and repair these components as necessary.
What to do if Upright Lifting Systems charger has been plugged into an AC outlet with different voltage than the AC switch setting on the charger?
If the Upright Lifting Systems charger has been plugged into an AC outlet with a different voltage than the AC switch setting: For 063944-001 ONLY, check the fuse inside the switch box and replace it if necessary. If the fuse is good, the charger has likely failed. For all other models, check the AC main circuit breaker and reset it if needed. Also, set the voltage selector switch to the proper voltage.
What to do if Upright Lifting Systems has high current in DC charging?
If there is high current in DC charging for Upright Lifting Systems, check for shorted DC output wires.
What to do if Upright Lifting Systems batteries are bad?
If one or more batteries are bad in your Upright Lifting Systems, check the water level and look for shorted cells. Replace any bad batteries.
What to do if Upright LX31 Lifting Systems fuse visible on front of charger has failed?
If the fuse on the front of the Upright Lifting Systems charger has failed, check for a DC output short circuit and replace the fuse.
What to do if Upright LX31 Lifting Systems has DC connection problems to batteries?
If there are DC connection problems to the batteries in your Upright Lifting Systems, check and repair the connections as necessary, and also check the fuse.
How to fix low battery voltage in Upright LX31 Lifting Systems?
If the battery voltage is below 18 Volts (too low to allow the charger to turn on) in your Upright Lifting Systems, charge the batteries to at least 24 Volts with an external charger. Then, disconnect the external charger and plug in the internal charger.
General| Brand | Upright |
|---|---|
| Model | LX31 |
| Category | Lifting Systems |
| Language | English |
Warning about operating near power lines.
Avoid driving with elevated platform on unstable surfaces.
Reminder to check for overhead obstructions before operation.
Warning against standing or sitting on guardrails.
Overview of the machine's main components.
Identification of platform and chassis controls.
Daily checks before operating the machine.
Checklist for daily inspection of machine components.
Procedure for checking and adding engine coolant.
Procedure for checking and adding engine oil.
Instructions for checking and filling hydraulic fluid.
Safety and procedures for checking battery fluid levels.
Procedure for switching between fuels on dual fuel models.
Safe procedures for driving the machine with the platform down.
Steps to secure the machine for transport.
Guidelines for safely lifting the machine with a crane.
Procedures for loading the machine onto a vehicle.
Explanation of outrigger controls and indicator lights.
Step-by-step guide to extending outriggers for leveling.
Procedure for retracting the outriggers.
How to release the parking brake for towing.
Daily shutdown and securing procedures.
