Upright TM12 - Service Manual

Other manuals for Upright TM12

Service & Parts Manual102 pages

Operator's Manual12 pages

Questions and Answers

M
Michael LeJul 27, 2025
What to do if the Upright TM12 Lifting Systems charger is plugged into the wrong voltage outlet?
- K
  kempgeorgeJul 27, 2025
  If the charger of your Upright Lifting Systems has been plugged into an AC outlet with a different voltage than the AC switch setting, then: * For model 063944-001 ONLY: Check the fuse inside the switch box and replace it if necessary. If the fuse is good, it indicates a charger failure. * For All Other models: Check the AC main circuit breaker and reset it if necessary. Set the voltage selector switch to the proper voltage.
W
william65Aug 2, 2025
How to fix a blown fuse on the Upright TM12 charger?
- T
  Timothy CurtisAug 3, 2025
  If the fuse visible on the front of the charger of your Upright Lifting Systems has failed, check for a DC output short circuit and then replace the fuse.
J
James MccormickAug 8, 2025
What to do if the Upright TM12 battery voltage is too low?
- C
  charlesbradleyAug 8, 2025
  If the battery voltage of your Upright Lifting Systems is below 18 Volts, charge the batteries to at least 24 Volts using an external charger. After reaching 24 Volts, disconnect the external charger and plug in the internal charger.
M
Melissa MartinAug 14, 2025
What to do if the Upright TM12 charger is overheating?
- M
  michellemclaughlinAug 15, 2025
  If your Upright Lifting Systems charger is overheated, move the machine to a cooler area and allow it to cool down before connecting it to an AC source.
J
Jonathan PattersonAug 20, 2025
What causes high current during DC charging in Upright TM12?
- H
  hammondleviAug 20, 2025
  If there is high current in DC charging of your Upright Lifting Systems, check for shorted DC output wires.