What to do if Upright Lifting Systems charger overheats?
If the Upright Lifting Systems charger overheats, move the machine to a cooler area. Allow the machine to cool before connecting to the AC source.
What to do if Upright LX41 has AC power problem?
If there is an AC power problem with your Upright Lifting Systems, the AC outlet, extension cord, or plug might be faulty, or the AC wire could be broken. Check and repair these components as necessary.
What to do if Upright Lifting Systems charger has been plugged into an AC outlet with different voltage than the AC switch setting on the charger?
If the Upright Lifting Systems charger has been plugged into an AC outlet with a different voltage than the AC switch setting: For 063944-001 ONLY, check the fuse inside the switch box and replace it if necessary. If the fuse is good, the charger has likely failed. For all other models, check the AC main circuit breaker and reset it if needed. Also, set the voltage selector switch to the proper voltage.
What to do if Upright LX41 has high current in DC charging?
If there is high current in DC charging for Upright Lifting Systems, check for shorted DC output wires.
What to do if Upright LX41 Lifting Systems batteries are bad?
If one or more batteries are bad in your Upright Lifting Systems, check the water level and look for shorted cells. Replace any bad batteries.
What to do if Upright LX41 fuse visible on front of charger has failed?
If the fuse on the front of the Upright Lifting Systems charger has failed, check for a DC output short circuit and replace the fuse.
What to do if Upright LX41 Lifting Systems has DC connection problems to batteries?
If there are DC connection problems to the batteries in your Upright Lifting Systems, check and repair the connections as necessary, and also check the fuse.
How to fix low battery voltage in Upright Lifting Systems?
If the battery voltage is below 18 Volts (too low to allow the charger to turn on) in your Upright Lifting Systems, charge the batteries to at least 24 Volts with an external charger. Then, disconnect the external charger and plug in the internal charger.
Never operate near power lines. This machine is not insulated.
Never operate on unstable surfaces or with elevated platform unless on firm, level surface.
Always check for overhead obstructions and other hazards before positioning.
Never climb or stand on guardrails. Distribute loads evenly.
Read manual, follow rules, inspect machine, never use damaged equipment, never climb assembly.
A checklist for daily inspections of components like battery, labels, chassis, tires, engine, and hydraulics.
Checks include modules, hydraulic oil, battery, engine oil, fuel, guardrails, tires, and damage.
Checks for drive, steering, and platform lift/lower functions, including alarms and emergency stops.
Instructions for using the emergency lowering control knob.
Instructions for using the emergency lowering control knob.
Instructions for using the emergency lowering control switch.
General| Brand | Upright |
|---|---|
| Model | LX41 |
| Category | Lifting Systems |
| Language | English |
To Next Page
