EasyManuals Logo

Upright MX Series User Manual

Upright MX Series
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4 Translation of the original instruction”
B-11 Check the oil level in the drive hub......................................
......34
B-12 Replace the hydraulic tank return filter....................................
......34
B-13 Check that the brake structure is correct..........................................
......35
Check table C program
C-1 Test platform overload pressure sensor and platform height sensor (if
equipped)........
......36
Check table D program
D-1 Check the chassis slider and the platform slider....................................
......39
D-2 Replace the hydraulic filter............................................
......39
D-3 Replace the wheel oil............................................
......40
D-4 Test function pump................................................
......41
Check table E program
E-1 Test or replace hydraulic oil..........................................
......42
E-2 Apply grease to steering shaft and wheel bearings................................
......43
Repair procedures
Platform controller
1-1 Method of removing the platform controller circuit board ................................
......46
1-2 Method of removing the handle........................................
......47
1-3 Method of removing the platform control alarm..................................
......47
1-4 Method of removing the platform controller emergency stop
button..........................
......48
Platform components
2-1 Method of removing the platform............................................
......49
2-2 Method of removing the platform extension board....................................
......50
Scissor arm components
3-1 Method of removing scissor arm parts (take 80W as an
example)............................
......52
3-1 Method of removing scissor arm parts (take 100W as an
example)...........................
......56
3-3 Method of replacing the pad............................................
......58
3-3 Lifting cylinder..................................................
......59
Chassis components
4-1 Hydraulic pump....................................................
......61
4-2 Hydraulic tank..................................................
......62

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Upright MX Series and is the answer not in the manual?

Upright MX Series Specifications

General IconGeneral
Lift Capacity500 lbs
Weight Capacity500 lbs
Platform Width30 in
Overall Width36 in
Overall Length8 ft
Stowed Length8 ft
Stowed Width36 in

Related product manuals