Upright MX Series - Brief Introduction; Specifications; Regular Maintenance Procedures; Check Table A Program

3 “Translation of the original instruction”
Table of content
Brief Introduction
Essentials............................................................
......6
Safety Rules
General Safety Rules....................................................
......7
Specification
Hydraulic specifications........................................................
......14
Hydraulic joint thread torque................................................
......15
Regular maintenance procedures
Check table A program
A-1 Check the operating manual and safety manual....................................
......23
A-2 Check the logo and label............................................
......23
A-3 Perform pre-operation check............................................
......24
A-4 Perform functional test..............................................
......24
A-5 Check the hydraulic oil level............................................
......25
A-6 Check for fuel leakage..............................................
.....
.25
A-7 Check the tire pressure..............................................
......26
Check table B program
B-1 Check the battery................................................
......27
B-2 Check the electrical wiring..............................................
......29
B-3 Check tire, wheel and groove nut torque..............................
......30
B-4 Test emergency stop..............................................
......30
B-5 Test the key switch..............................................
......31
B-6 Test drive brakes............................................
......31
B-7 Test drive speed - stowed position....................................
......32
B-8 Test drive speed - raised position....................................
......32
B-9 Check the electrical contactor............................................
......33
B-10 Perform hydraulic oil analysis............................................
......33