3. Enter the RADIUS server IP address and RADIUS Port settings of your RADIUS
server.
4. >Enter the RADIUS key of your RADIUS server.
5. Enter the Re-authentication time, in minutes.>
6. If required for your connection to the RADIUS server, select Pre-authentication. This
option is not available with WPA with 802.1x (RADIUS).
None
None disables all wireless security on your access point.
Note: The setting of None is not recommended since without any encryption
enabled, your network will be vulnerable to outside malicious attacks.
MAC Filter
In this area you can control which wireless devices are allowed or denied access to the
access point based upon their MAC addresses. The MAC address can usually be found either
on a label on the external wireless product or in the configuration utility of the wireless
client, depending on the wireless device you are using.
file:///G|/CSO/T-Writer%20Repository/Networking/5455%20MAXg%20CR%20AP/Regulatory%20Preview/security.html (6 of 8)4/24/2007 5:15:53 PM
To Next Page
Loading...
