■ Security type and key, psk, or passphrase.
Refer to your device's documentation to determine how to change these
settings.
If you still have trouble using the access point, follow the procedure below that best
describes your symptom.
Installation and Configuration
The networking device I am using does not have a DHCP server.
The access point is connected to a live power source, but the power LED is off.
The installation procedure did not start when I inserted the USRobotics Installation CD-
ROM.
The detection utility does not find the Wireless MAXg Access Point.
I cannot access the configuration pages.
After I performed a firmware upgrade, the access point did not display its status page.
Wireless Connections
The Wireless MAXg Access Point does not appear when I scan for it with a wireless client.
My client is not communicating with the Wireless MAXg Access Point.
I am no longer able to access the Internet.
My client does not establish a wireless connection to the Wireless MAXg Access Point
file:///G|/CSO/T-Writer%20Repository/Networking/5455%...g%20CR%20AP/Regulatory%20Preview/troubleshooting.html (2 of 3)4/24/2007 5:15:54 PM
To Next Page
Loading...
