Wireless MAXg Access Point:
User Guide
My client is not communicating with the Wireless Nd1 Access
Point.
Solution:
See "For wireless connections" in the basic troubleshooting procedure.
Solution:
In the configuration utility for your wireless card or adapter, ensure that you are
connecting to the correct Wireless MAXg Access Point by verifying the WLAN MAC
address. You can find the WLAN MAC address on the label on the bottom of the access
point.
Solution:
The access point may not have received a valid IP address for your network. Check the
LAN configuration page of the access point.
● If the IP address is set to Dynamic, make sure that the access point is connected to
a DHCP server.
● If you use a static IP address verify that it is in the same subnet as your client's IP
address.
file:///G|/CSO/T-Writer%20Repository/Networking/5455%...CR%20AP/Regulatory%20Preview/trouble_client_comm.html (1 of 2)4/24/2007 5:15:56 PM
To Next Page
Loading...
