Wireless MAXg Access Point:
User Guide
Frequently Asked Questions
How do I restore the access point to its factory default settings?
First, be aware that restoring the factory default settings loses all
configuration changes that you made.
If you are certain that you need to restore the factory default settings, use a
small object such as a paper clip to press in and hold the reset button on
the back of the access point for 7 seconds.
After you restore the access point,
reconfigure the basic settings of the
access point, or, if you made a backup of your settings,
restore the settings
by using the backup.
Can I use the access point if my networking device does not have DHCP?
Yes. By default, the access point is configured to obtain an IP address from
a DHCP server, but you can manually set the IP address of the access point
from the configuration pages. For information on assigning a static IP
address to the access point, see
The networking device I am using does not
have a DHCP server.
© 2007 U.S. Robotics Corporation
file:///G|/CSO/T-Writer%20Repository/Networking/5455%20MAXg%20CR%20AP/Regulatory%20Preview/faq.html (1 of 2)4/24/2007 5:15:58 PM
To Next Page
Loading...
