Solution:
The access point may not be responding. Try the following:
1. Reconnect by following the steps in
Connecting a Wireless Client.
2. If you still are not communicating with the access point, restore the factory default
settings of the access point to reactivate it.
Note: When you restore the factory default settings, the access point will
lose all custom settings.
To restore the factory default settings, use a small object such as a paper clip to
press in and hold the reset button on the back of the access point for 7 seconds.
3. After you restore the access point,
reconfigure the basic settings of the access
point, or, if you made a backup of your settings,
restore the settings by using the
backup.
Return to Troubleshooting page
© 2007 U.S. Robotics Corporation
file:///G|/CSO/T-Writer%20Repository/Networking/5455%...CR%20AP/Regulatory%20Preview/trouble_client_comm.html (2 of 2)4/24/2007 5:15:56 PM
To Next Page
Loading...
