Wireless MAXg Access Point:
User Guide
I cannot access the configuration pages.
1. In your Web browser, make sure that you are entering the correct IP address for
the access point. To find the IP address, see
Logging in to the Configuration Pages.
2.
Configure your Web browser so that the HTTP Proxy feature of your Web browser.
3. If you are trying to access the configuration pages wirelessly, try to access them
with a wired connection as follows:
A. Using a computer connected by Ethernet cable to the same networking
device as the access point, start a Web browser.
B. Enter the IP address of the access point and press ENTER.
■ If you can access the configuration pages with a wired connection, you
are experiencing a wireless connectivity issue. See
"For wireless
connections" in the basic troubleshooting procedure.
■ If you cannot access the configuration pages with a wired connection,
reboot the access point by disconnecting and then reconnecting its
power supply.
If you have rebooted the access point but still cannot access the
configuration pages, restore the factory default settings of the access
point to reactivate it.
Note: When you restore the factory default settings, the
access point will lose all custom settings.
file:///G|/CSO/T-Writer%20Repository/Networking/5455%...0CR%20AP/Regulatory%20Preview/trouble_wui_access.html (1 of 2)4/24/2007 5:15:55 PM
To Next Page
Loading...
