To restore the factory default settings, use a small object such as a
paper clip to press in and hold the reset button on the back of the
access point for 7 seconds.
After you restore the access point to its factory default settings,
reconfigure the basic settings of the access point, or, if you made a
backup of your settings,
restore the settings by using the backup.
Return to Troubleshooting page
© 2007 U.S. Robotics Corporation
file:///G|/CSO/T-Writer%20Repository/Networking/5455%...0CR%20AP/Regulatory%20Preview/trouble_wui_access.html (2 of 2)4/24/2007 5:15:55 PM
To Next Page
Loading...
