US Robotics MAXg - Page 81

Wireless MAXg Access Point User Guide
5. Disconnect and then reconnect the power supply of the access point.
6. Press ENTER.
You should see a message in the command window stating that the image was
transferred.
7. Wait for the upgrade to finish. When the wireless LED
turns on, the upgrade is
done.
Return to Troubleshooting page
© 2007 U.S. Robotics Corporation
file:///G|/CSO/T-Writer%20Repository/Networking/5455%...g%20CR%20AP/Regulatory%20Preview/trouble_upgrade.html (4 of 4)4/24/2007 5:15:56 PM