Page 25
LPX SEED TREATER
17. Have a certified electrician provide
power to the seed treating system.
Provide convenient shutdown switches,
comply with local electrical codes and
ensure that the system is properly
grounded and bonded. The USC
system must be connected to the same
electrical requirements as specified in
the main control panel on the power
requirement tag, or the electrical
schematic shipped with the piece of
equipment. This will power the USC
LPX seed treater and any attached
conveyors.
19. Attach the communication cable from the pump stand(s) control panel(s) to the
bottom of the treater control panel for an automated pump stand or to the auxiliary
connection plug on the bottom of the treater control panel for a manual pump stand.
20. Provide 110V single phase power to both the main control panel and the pump
stand(s).
Flexible conduit is recommended for main
power supply.
LPX AUTOMATED TREATER SET - UP
18. There is a USB port located on
the bottom of the panel that may
be used to download reports to a
compact flash device. The flash
device must be in FAT 32 format.
USB Port
NOTICE
AVIS
Conduit flexible est recommandé pour
l'alimentation principale.
To Next Page
