9
n Unlock the controller by pressing and holding the MENU button for 3
seconds
n Press and hold the SET/REGEN button
n Confirm by pressing the SET/REGEN button
n Select IMMEDIAT using the UP/DOWN buttons
n Confirm by pressing the SET/REGEN button
n Press the MENU
n Skip „BRINING” by pressing the SET/REGEN button
n Pour 12kg (half of bag) of salt to the salt storage tank
n Set the by-pass valve in:
n inlet open, outlet open
n Open a tap in a possibly highest point of the object and wait for
venting.
n Wait until the end of
BACKWASHING 1. Time remaining is
shown on a display.
n Wait until the end of RINSING.
Time remaining is shown on a display.
n Wait until the end of REFILLING.
Time remaining is shown on a display.
n Wait until „preparing to work” message disappear.
Amount of water
Delay
Immediat
Rinsing 1
Rinsing 2
Refilling
Rinsing 1
Time remaining 07:25
Rinsing 2
Time remaining 06:19
Refilling
Time remaining 09:52
Informations shown on a display, are presented below:
Last Regen.
Remaining
capacity
Flow
rate
MODE
To Next Page
Loading...
