2
4. Parts list
5. Installation
Before installation make sure the package contains all parts. The package should contain:
n Water softener
n Transformer
n Instruction manual
n By-pass
n Hex key
n 1” coupling
Before installation please read this manual carefully and comply to all safety precautions related to
starting-up and operation. In case of any questions please contact the dealer or the manufacturer.
Before installation remove all parts out of the box. Check if the device has not been damaged during
transport. All comments should be reported to the seller immediately.
The device should be removed from the box carefully. The softener can be heavy, so when carrying,
grab it "from the bottom". It is forbidden to move the device grabbing hoses, by-pass and other delicate
parts. Avoid moving across the floor. It is forbidden to drop the device, putting it on sharp or angular
edges and turning upside-down, because this may lead to permanent damage of the softener. The
device should be transported only in an upright position, otherwise it may damage the controller.
When installing the softener:
- make sure you have the knowledge or hire a professional
- make sure the placement area is clean, flat, stable and it can withstand the load of the softener filled
with water and salt
- make all connections according to the local laws and regulations
- to seal all threaded, gasket-free connections use PTFE tape only. Using tows is prohibited and may
result in connections damage.
Softener must be preceded with at least 50 micron rating sediment pre-filter (eg. UST-M’s PS or PP).
Drain hose and brine overflow hose should be connected to the sewage system separately
using siphon and air gap, in order to prevent the backflow of odors and bacteria inside the
device.
To Next Page
Loading...
