3-8
Basic Operation
6 Remove the finished copies from the inner tray.
Adjusting Density
Use this procedure to adjust the density when copying.
NOTE: You may choose Auto mode as the default setting (refer to Density on page 8-46).
The procedure for adjusting the density of copies is explained below.
1 Press the Function Menu key. Function Menu appears.
2 Press the U or V key to select [Density].
3 Press the OK key. Density appears.
4 Press the U or V key to select [Auto] or [Manual].
5 Press the OK key.
When [Manual] is selected, Manual appears. Press the
U or V key to select your desired density and then press
the OK key.
Completed. is displayed and the screen returns to the
basic screen.
6 Press the Start key. Copying begins.
Density Adjustment Option Description
Manual Adjust density using 7 levels.
Auto Optimum density is selected according
to the density of the original.
To Next Page
Loading...
Need help?
General
