What to do if Utax All in One Printer displays 'Memory is full'?
If your Utax All in One Printer displays 'Memory is full. Print job cannot be processed completely,' the job cannot continue because the memory is full. Press the OK key to print the scanned pages, noting that the print job will not be fully processed. Alternatively, press the Stop key to cancel the job.
How to fix dark printouts from Utax All in One Printer?
If your Utax All in One Printer is producing printouts that are too dark, it could be due to the density settings. If the machine is in Auto Density mode, set the correct density level. Alternatively, if it's in Manual Density mode, select the appropriate density level.
Why my Utax All in One Printer cannot print?
If your Utax All in One Printer is unable to print, check a few things. Ensure the power cord is plugged into an AC outlet and that the power switch is turned on. Verify the printer cable is securely connected. If the machine was powered on before connecting the printer cable, power it on again after connecting the cable. Check if the print job is paused and, if so, press [Resume]. Finally, if an error message is displayed, follow the corresponding procedure.
Why Utax All in One Printer ejects blank sheets?
If your Utax All in One Printer is ejecting blank sheets, check how the originals are loaded. When using the platen, place originals face-down and align them with the slit glass. When using the document processor, place originals face-up.
How to clean Utax All in One Printer dirty printouts?
If your Utax All in One Printer is producing dirty printouts, the platen or the document processor might be dirty. Clean the platen or the document processor to resolve this issue.
What to do if my Utax All in One Printer shows 'Machine failure. Call service.'?
If your Utax All in One Printer displays 'Machine failure. Call service,' an internal error has occurred. Make a note of the error code displayed on the Message Display. Turn off the machine, unplug the power cord, and contact your Service Representative.
What to do if Utax All in One Printer says 'Load paper in cassette 1'?
If your Utax All in One Printer displays 'Load paper in cassette 1,' it means the indicated cassette is out of paper. Load paper into cassette 1.
What does 'Non-genuine Toner' mean on my Utax All in One Printer?
The 'Non-genuine Toner' message on your Utax All in One Printer indicates that a non-genuine toner is being used. The manufacturer is not responsible for damage caused by non-genuine toner, so it's recommended to use only genuine toner containers.
Why is the top edge of the paper dirty after printing with my Utax All in One Printer?
If the top edge or back of the paper is dirty after printing with your Utax All in One Printer, the inside of the machine might be dirty. Clean the inside of the machine.
How to fix Utax All in One Printer when it cannot feed originals?
If your Utax All in One Printer cannot feed originals, make sure the originals are placed correctly in the document processor. Align the original width guides securely before placing the originals.
General| Brand | Utax |
|---|---|
| Model | CD 5130 |
| Category | All in One Printer |
| Language | English |
To Next Page
