6-26
Using Various Functions > Functions
Priority Override
Suspends the current job and gives a new job top priority.
The suspended job resumes after the other job is finished.
(Value: [Off] / [On])
Quiet Mode
Lower print and scan speed for quiet processing.
Select this mode when the running noise is uncomfortable.
It is possible to set the use of Quiet Mode for each function, such as copying and sending.
(Value: [Off] / [On])
Skip Blank Page
When there are blank pages in a scanned document, this function skips the blank pages and prints only pages that are
not blank.
When set to [High], the level at which blank paper is recognized is higher.
The machine detects blank pages, saving unnecessary printing without the need to check for blank pages in the
document.
Select [Low], [Middle] or [High] in [On].
• This function is not available if current job was an override.
• Priority override may not be available depending on the status of the current print job and memory usage.
• The processing speed will be slower than normal when in Quiet Mode.
• This cannot be used when [Prohibit] is set for "Specify for Each Job".
Specify for Each Job (page 8-39)
The originals with punched holes or originals printed on a colored substrate may not be recognized as blank pages.
Print from
Box
Print from
Box
Send
To Next Page
Loading...
Need help?
General
