10-27
Troubleshooting > Troubleshooting
1105 Failed to send via SMB. Check the following settings.
[System Menu/Counter] key > [System/Network] >
[Network] > [TCP/IP Settings] > [Protocol Detail] >
[SMB Client (Transmission)]
page 8-26
Failed to send the e-mail. Select [On] of the SMTP settings on the Embedded
Web Server RX.
page 2-53
Failed to send via FTP. Check the following settings.
[System Menu/Counter] key > [System/Network] >
[Network] > [TCP/IP Settings] > [Protocol Detail] >
[FTP Client (Transmission)]
page 8-26
1106 Failed to send the e-mail. Check the sender address of SMTP on the Embedded
Web Server RX.
page 2-53
1131 Failed to send via FTP. Enable the SSL.
[System Menu/Counter] key > [System/Network] >
[Network] > [Secure Protocol] > [SSL]
page 8-30
1132 Failed to send the e-mail. Check the following of the SMTP server.
• Is SMTP over SSL available?
• Is the encryption available?
Refer to the
Embedded
Web Server
RX User
Guide.
Failed to send via FTP. Check the following of the FTP server.
• Is FTPS available?
• Is the encryption available?
—
2101 Failed to send via SMB. Check the network and SMB settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send via FTP. Check the network and FTP settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send the e-mail. Check the network and Embedded Web Server RX.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• POP3 server name of the POP3 user
• SMTP server name
page 2-53
Error
Code
Message Corrective Actions
Reference
Page
To Next Page
Loading...
