Utax P-C4580DN - Page 100

Document Box
4-18
Paper Output (Output location selection)
Select the output location. For details, refer to Paper Output (Selecting the Paper Output Location) on page 6-31.
1 In the Copies menu or the Paper Selection menu, press
[Function] ([Right Select]). The Function menu appears.
2 Press  or  to select Paper Output.
3 Press [OK]. The Paper Output menu appears showing the
available output locations.
4 Press  or  to select the desired output location.
5 Press [OK]. The selected output location is stored and the Function
menu reappears.
Collate (Collate Setting)
Select the collate setting.
1 In the Copies menu or the Paper Selection menu, press
[Function] ([Right Select]). The Function menu appears.
2 Press  or  to select Collate.
3 Press [OK]. The Collate screen appears.
4 Press  or  to select On or Off.
5 Press [OK]. The selected mode is set and you return to the function
menu.
Note The screen varies depending on the installed options.
Function: a b
********************-
2 Collate
3 Offset
1 Paper Output
Paper Output: a b
********************-
2 Tray A
3 Tray B
1 *Job Separator
Note The screen shown appears when a 4,000-sheet Finisher is
installed.
Function: a b
********************-
2 Collate
3 Offset
1 Paper Output
Collate: a b
1 Off
********************-
1 *On