Utax P-C4580DN - Page 166

Operation Panel
6-42
IP Address (IP address setting)
Set the IP addresses.
1 In the IPv4 Setting menu, press  or  to select IP Address.
2 Press [OK]. The IP Address screen appears.
3 Use the numeric keys to set the IP address.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing  or .
Use  and  to move the position being entered, which is shown
highlighted.
4 Press [OK]. The IP address is stored and the IPv4 Setting menu
reappears.
Subnet Mask (Subnet mask setting)
Set the IP subnet mask.
1 In the IPv4 Setting menu, press  or  to select Subnet Mask.
2 Press [OK]. The Subnet Mask screen appears.
3 Use the numeric keys to set the subnet mask.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing  or .
Use  and  to move the position being entered, which is shown
highlighted.
4 Press [OK]. The subnet mask setting is stored and the IPv4 Setting
menu reappears.
Note When you enter the IP address, be sure to set the DHCP setting to Off.
IP Address: a b
/**0. 0. 0. 0
Note When you enter the subnet mask, be sure to set the DHCP setting to Off.
Subnet Mask: a b
/255. 255. 0. 0