Utilitech 50AC-110N - User Manual

Questions and Answers

D
David HoweAug 11, 2025
What to do if my Utilitech 50AC-110N Water Pump runs but no water comes out?
- R
  Rachel Cole MDAug 12, 2025
  If your Utilitech Water Pump runs but isn't discharging water, consider the following: * Check for any kinks in the hose and straighten them out. * Ensure the pump is properly primed. * Inspect the impeller for defects and replace it if necessary. * Make sure that the suction lift isn't too high; if it is, move the pump closer to the water source. * Reduce the discharge height. * Check for and clean any clogs in the inlet.
J
jeffrey63Aug 17, 2025
Why does my Utilitech Water Pump motor run too hot?
- T
  tiffanygreenAug 17, 2025
  Several factors can cause a Utilitech Water Pump motor to overheat: 1. Incorrect voltage: Ensure the pump is connected to a 115-volt outlet. 2. Restricted discharge hose: Increase the hose diameter to 3/4 inch. 3. Damaged impeller: Replace the impeller. 4. Plugged or kinked discharge: Clean and straighten the hose. 5. Insufficient air flow: Ensure ample fresh air is available around the motor.
M
Margaret WilsonAug 25, 2025
How to fix a Utilitech Water Pump that won't prime?
- C
  chandleralexaAug 25, 2025
  If your Utilitech Water Pump won't prime or retain its prime, consider these potential causes: * The pump may not be primed initially. * The suction lift might be too high; move the pump closer to the water source. * There might be a kink in the hose; straighten it out. * The hose fitting may not be tight on the inlet; tighten it. * There could be an air leak in the suction hose; repair or replace the hose.
K
Kristina JohnsonAug 29, 2025
What causes low flow rate in a Utilitech Water Pump?
- H
  Heidi HenryAug 29, 2025
  A low flow rate in your Utilitech Water Pump can be due to several reasons: * A kinked hose: Straighten the hose. * A clogged impeller: Clear any obstructions. * A worn impeller: Replace the impeller. * Excessive hose length: Reduce the length of the inlet and outlet hose.
J
Joseph MitchellSep 4, 2025
What to do if my Utilitech 50AC-110N Water Pump will not run?
- T
  tammy17Sep 4, 2025
  If your Utilitech Water Pump isn't running, check the following: * Power supply: Verify the unit is plugged into a 115-volt outlet. * Impeller: Clean the pump cavity and impeller if it's jammed. * Motor: If the motor overheated, wait fifteen minutes for it to cool down; it has an automatic thermal protector.