7
Face Plate
Screws (4)
Face Plate
Gasket
Pump Cavity
Impeller
1
6
Outlet Hose
Water
Source
Discharge
Water
Reinforced
inlet hose must
be 6 ft. or less
5
PRIMING AND STARTUP
6. This unit is shipped with a puddle vac (C) accessory
which allows it to remove water from at surfaces.
After attaching inlet hose (B) in step 2, attach the
puddle vac (C) onto the end of the inlet hose (B) and
place it on the surface to be pumped.
CAUTION: Before water is completely gone, unplug the
pump. DO NOT RUN PUMP DRY!
A
B
C
5. To reduce friction, do not coil or kink the hoses. When
pumping from a well or stream, raise the inlet hose (B)
a few inches o the bottom to avoid pumping in debris
which can damage the pump (A).
B
A
CARE AND MAINTENANCE
A
1. Always drain pump (A) when not in use. If pump is going
to be out of use for a month or longer, ush with fresh
water and remove face plate cover. Using a screwdriver
(not included), remove impeller. Clean inside pump (A)
cavity and apply a generous coating of petroleum jelly
(not included) to the inside of the cavity and the impeller
before replacing the impeller. The pump should be
checked frequently for proper operation. If anything has
changed since the pump was new, it should be repaired
or replaced.
To Next Page
Loading...
Need help?
General
