Utilitech UT100USP - User Manual

Questions and Answers

M
Mackenzie Roberts MDAug 6, 2025
What to do if my Utilitech UT100USP Water Pump runs but no water is delivered?
- K
  Kristen EdwardsAug 7, 2025
  If your Utilitech Water Pump runs but doesn't deliver any water, several factors could be at play. First, ensure the pump is properly primed following the instructions. Second, check all connections on the suction line for air leaks using shaving cream. A leaking foot valve could also be the culprit, requiring replacement. Lastly, verify that the pipe size matches the suction and discharge ports on the pump; if it's too small, re-pipe accordingly.
R
Robert ParkAug 13, 2025
Why does my Utilitech UT100USP motor run hot and overload, or just hum?
- K
  kellieandersonAug 13, 2025
  If your Utilitech Water Pump's motor runs hot and the overload kicks off, or it only hums, the issue might stem from a blown fuse or tripped circuit breaker. In this case, disconnect the power and replace the fuse or reset the circuit breaker. Another potential cause is low voltage. Ensure you check the voltage being supplied to the pump.
J
John ThomasAug 20, 2025
Why is my Utilitech UT100USP not delivering water to full capacity?
- C
  Christopher ColemanAug 20, 2025
  If your Utilitech Water Pump does not deliver water to its full capacity, it could be due to several reasons. The water being pumped might be lower than estimated, in which case a deep well jet will be needed if the water being pumped is more than 25 ft. Steel piping, if used, might be corroded or limed, causing excess friction; consider replacing it with plastic pipe where possible, otherwise with new steel pipe. Additionally, the piping might be too small in size, requiring you to re-pipe using the size of suction and discharge ports on the pump. Finally, the pump might not be supplied with enough water, and you may need to add additional well points.
M
marshallannaAug 28, 2025
How to fix a Utilitech UT100USP when the motor will not run?
- C
  crystalfoxAug 28, 2025
  If the motor of your Utilitech Water Pump will not run, the problem may be a blown fuse or tripped circuit breaker. To resolve this, disconnect the power and replace the fuse or reset the circuit breaker. Another possible cause is that the voltage is too low. You should check the voltage being supplied to the pump.