5
Lowes.com
SAFETY INFORMATION
®
11. Risk of electric shock. Can shock, burn
or kill.
• The pump is supplied with a 3-conductor
grounding-type cord. Connect only to a properly
grounded, Ground Fault Circuit Interrupter (GFCI)
protected outlet. Do not lift the pump by the
electrical cord. See Figure 1.
Match the motor voltage and the power supply
voltage. The supply voltage must be within
+/- 10% of the motor nameplate voltage. Incorrect
voltage can cause re or seriously damage the
motor and will void the warranty. If in doubt,
consult a licensed electrician.
• The pump is non-submersible. Keep the motor
dry at all times. Do not wash the motor. Do not
immerse. Protect the motor from wet weather.
• If using an extension cord, use only a UL
approved indoor/outdoor, 3-wire, grounding-
type cord. Do not allow any part of the cord or
the receptacle ends to sit in water or in damp
locations.
• Unplug the pump before servicing. To avoid
fatal shocks, proceed as follows if the pump
needs servicing:
A. Disconnect the power to the pump outlet box
before pulling the pump plug.
B. Take extreme care when changing fuses. To
reduce the chance of fatal electrical shocks,
DO NOT stand in water or put your nger in the
fuse socket.
C. Ground the pressure switch or motor before
before running this pump.
D. Plug pump into a GFCI protected grounded
outlet only
PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not attempt
to install the product.
Estimated Installation Time: 15 minutes
Tools and Materials Required for Installation (not included): Pliers
Helpful Materials (not included): 1 in. Foot Valve w/ Strainer, Discharge Pipe Hose,
Rigid Pipe, PTFE Pipe Thread.
115V, GFCI
protected,
grounded
outlet box
1
To Next Page
Loading...
Need help?
General
