To Next Page
M
Michael RichardsJul 31, 2025
What to do if my Utilitech PPSU33 Water Pump does not start?
- JJeffrey SmithJul 31, 2025
If your Utilitech Water Pump isn't starting, here are a few things to check: * Make sure the sensor probes aren't covered in debris; if they are, clean them. * Check the fuse or breaker and replace or reset if necessary. * Ensure the pump is securely plugged in. * If there's a thermal overload, unplug the pump for 30 minutes, then plug it back in. * Clean any corrosion from the plug prongs. * If none of these steps work, it's possible the motor has failed.
General
