Utilitech 0955552 - User Manual

Questions and Answers

G
gomezshannonAug 9, 2025
What to do if my Utilitech Water Pump will not deliver water or develop pressure?
- J
  Jason TurnerAug 10, 2025
  If your Utilitech Water Pump isn't delivering water or developing pressure, there might be several reasons. First, ensure the pump casing is filled with priming water. Second, check for leaks in the suction line and repair or replace if necessary. Third, if the discharge line is closed, open the ball valve and some outlets or faucets to allow air to escape. Also, make sure the suction line or valve isn't closed; if it is, open it. Lastly, a leaking foot valve should be replaced, and a clogged suction screen needs cleaning or replacement.
C
clarkjudyAug 17, 2025
How to fix a Utilitech 0955552 Water Pump with little or no discharge?
- D
  Danielle ThompsonAug 17, 2025
  If your Utilitech Water Pump has little to no discharge, several factors could be responsible. Ensure the pump casing is initially filled with water. If the suction lift is too high or too long, move the pump closer to the water source. Repair any holes or air leaks in the suction line, using pipe tape and sealing compound. Check that the foot valve is appropriately sized for the piping, or install one size larger. Ensure the foot valve or suction line is submerged adequately in the water. Verify the motor wiring is correct by checking the wiring diagram. Replace a leaking casing gasket. Finally, make sure the suction or discharge line valves are open.
C
charles05Aug 25, 2025
Why is my Utilitech 0955552 Water Pump losing suction?
- T
  Terry FieldsAug 25, 2025
  If your Utilitech Water Pump experiences a loss of suction, it could be due to a few reasons. Check for air leaks in the suction line and repair or replace any faulty sections. If the suction lift is too high, try moving the pump closer to the water source. Also, inspect the foot valve or strainer for clogs and unclog if necessary.
K
Katelyn NguyenSep 1, 2025
What to do if my Utilitech Water Pump will not start or run?
- C
  Christopher LeeSep 1, 2025
  If your Utilitech Water Pump will not start or run, there are several potential causes. Begin by checking the wiring diagram on the motor to ensure it's wired correctly. Replace any blown fuses or close any open circuit breakers. Inspect all wiring connections for loose or broken wires. If there's a stone or foreign object lodged in the impeller, disassemble the pump and remove it. If the thermal overload has opened the circuit, allow the unit to cool down before restarting, after identifying the reason for the overload.