Utilitech PPTP1 - Pump Specifications; Power Supply Details; Operating Water Temperature; Circuit Protection Requirements

2
TABLE OF CONTENTS
Specifications ................................................................................................................................... 2
Construction ..................................................................................................................................... 2
Safety Information ............................................................................................................................ 3
Performance ..................................................................................................................................... 4
Preparation ....................................................................................................................................... 4
Installation Instructions ..................................................................................................................... 5
Troubleshooting ............................................................................................................................... 7
Warranty ........................................................................................................................................... 8
SPECIFICATIONS
Power supply required ............................................................................................ 115V, 60 HZ
Water temperature range ................................................................................ Max. 77°F (25°C)
Individual branch circuit required .............................................. 5-amp minimum (15-amp max.)
Discharge connection ..................................................... 3/4 in. garden hose thread connection
Discharge hose needed ................................................. 5/8 in. or larger discharge garden hose
Power cord ............................................................................................ SJTW, 18AWG/3C, 6 ft.
CONSTRUCTION
Pump body ......................................................... Reinforced high strength plastic pump housing
Impeller ....................................................................................... Nitrile butadiene rubber (NBR)
Motor housing ...................................................................................................... Zinc-aluminum