EasyManuals Logo
Home>Utilitech>Water Pump>PPTP1

Utilitech PPTP1 User Manual

Utilitech PPTP1
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
WARRANTY
This product is warranted against manufacturing defects for a period of 12 months from the date of
purchase. Any misuse, abuse, or modification automatically voids this warranty. The distributor will
repair or replace the pump if, in its sole determination, the pump failed due to defects in materials or
workmanship.
WARRANTY EXCLUSIONS
1. Neither the distributor, nor the store that sold this pump shall in any event be liable for any labor or
similar expenses incurred in removing or repairing this pump.
2. The distributor specifically disclaims any implied warranties of merchantability and fitness for a
particular purpose.
3. In no event shall the distributor be liable for consequential, incidental, or special damages resulting
from or related in any manner to any distributor components or accessories.
4. The distributor disclaims all liability for improper installation or improper use of this product.
Some states do not allow the exclusion or limitation of incidental or consequential damages.
The above limitations and exclusions may not apply to you. In addition to the rights given you
by this warranty, you may also have other rights which vary from state to state.
For warranty claims, DO NOT RETURN PUMP TO THE STORE!
Call our customer service department at: 1-800-346-7611, Monday Friday, 8:00 a.m. 5:00 p.m.,
EST.
Printed in China
Problem
Possible Cause
Corrective Action
Pump does
not start or
run
1. Blown fuse
2. Tripped breaker
3. Plug disconnected
4. Corroded plug
5. Motor overheated
1. Replace fuse
2. Reset breaker
3. Secure plug
4. Clean plug prongs
5. Unplug the power and wait for 30
minutes, then plug in the power cord
Pump
doesn’t
prime
1. Air leak in suction line
2. Impeller clogged
3. Impeller worn or damaged
4. Impeller dry
1. Repair suction line by tightening hose
connection or replacing hose washer if
necessary
2. Remove blockage
3. Replace impeller
4. Add water to the pump inlet
Flow rate is
too low
1. Hose kinked or coiled
2. Strainer or hose blocked
3. Discharge hose too long
4. Worn impeller
1. Straighten hose
2. Clean strainer or hose
3. Shorten the hose (50 ft. max)
4. Replace the impeller

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Utilitech PPTP1 and is the answer not in the manual?

Utilitech PPTP1 Specifications

General IconGeneral
BrandUtilitech
ModelPPTP1
CategoryWater Pump
LanguageEnglish

Related product manuals