11
Product Maintaining
1. Cleaning side brushes
Clean the side brushes when it gets dirty and replace if it’s damaged.
Note: Before replacing side brushes, check and make “L”, “R” mark on side brush match
with the “L”,”R” mark on bottom base of the robot.
2. Cleaning dust bin and filter
Clean and empty dust bin after each use, steps are as shown in below figures.
Note:
*After taking out dust bin, check whether there is foreign matter stuck in suck passage and clean it.
*Wash HEPA filter after 15-30 days’ use.
*After wash HEPA and primary filter, dry them in ventilated&cool place and install after they are dry.
*Dust bin and filters (including HEPA and primary filter) could be replaced if needed.
A B C D
E F G
To Next Page
Loading...